'

Sage creates 5TB SSD Controller

PRESS RELEASE

Sage creates 5TB SSD Controller

Sage creates 5TB SSD Controller

 

A new data storage solutions company focusing on Solid State Disk (SSD) technology has revealed itself by announcing a new SSD controller IC that enables SSDs with densities up to 5 Terabytes (TB). The company, Sage Microelectronics, is currently shipping in volume 2.5 TB SSD units on a single PCB with a standard 2.5" form-factor.

Sage Micro's new technology enables a single SSD controller IC to address up to 5TB of flash memory (on an array of 10 X 4 X 128GB eMMC BGA modules), achieving an industry first in high density and small form factor. The Sage S681 device, currently in mass production, employs a SATA II interface to drive 10 channels of SD, MMC or eMMC flash memory cards, with each channel supporting up to 512GB of flash memory.



"Until now, cost-competitive SSD densities were limited to 1 TB by the maximum capacity of flash memory chips, and by the fan-out limitations imposed on flash controllers by the high number of interface traces required for each memory device," explained Dr. Jerome Luo, founder and President of Sage Microelectronics. "Sage decided to leverage the highly competitive pricing of flash memory cards-such as eMMCs-to develop an SSD controller that can effectively address up to 5TB of data."

 

Sage creates 5TB SSD Controller



eMMC Enables Higher Density, Eases Design & Inventory Management


By offloading the management and high pinout interface of individual flash memory chips to the flash controller IC embedded in each flash memory card, the new Sage S681 can effectively manage ten memory cards, increasing SSD capacity ten-fold.

Replacing flash memory chips with flash memory cards does not increase per-byte cost for the Sage SSD controller architecture, because the market has driven flash controller IC pricing to become highly commoditized. This results in flash memory cards being price competitive with the underlying cost of the component flash memory chips themselves. The use of JEDEC-compliant memory cards instead of discrete flash ICs also enables SSD manufacturers to mix-and-match inventory, further reducing testing cost, inventory management complexity and firmware version control.

Sage developed a propriety multi-core architecture for its SSD controller IC. Unlike single core SSD controllers from other vendors, the Sage S681 is built on a multi-core processor that devotes a single concise RISC CPU core to SATA bus management, plus additional cores to handle two memory card channel interfaces each. This enables clear firmware partitioning between the SATA interface and memory card interface, simplifying software upgrades, testing and verification.

The Sage S68X family of SSD controllers includes three devices: the S681 supports 10 memory channels, the S682 supports 5 memory channels, and the S685 support 4 memory channels. All three devices are currently in mass production, and all are priced under USD 5.00, depending on volume.

The S681 is available in a BGA 207 package.

The S682 is available in a LQFP 128 package.

The S685 is available in a QFN 88 package.

Sage Micro also offers a portfolio of low-density SATA II SSD flash controller solutions.



Experienced Team of Storage Innovators Behind New Venture


Sage Microelectronics was formed by leading technologists with corporate experience in flash memory and controller design. The company is led by President Jianjun (Jerome) Luo, PhD., who also serves as Director of the prestigious Micro Electronics Research Institute (MERI) at Hangzhou Dianzi University, China.

The company's founding team includes senior executives that co-founded storage technology developer Baleen Systems, and held senior executive and technology positions at Synopsis, IBM, Maxtor, Oak Technologies and other Silicon Valley companies. With more than 60 patents granted between them, Sage Micro's core team has decades of experience in innovative storage technology development.

The company is financially backed by China-based venture capital and corporate investment from the Cybernaut Investment Fund, Enjoyor Ltd. and Shenzhen Jinchang Asset Management Co.

  

Join the discussion on Sage Electronics and the 5TB SSD controller on the OC3D Forums.

 

«Prev 1 Next»

Most Recent Comments

04-11-2014, 03:51:52

ShaunB-91
That won't be cheap!Quote

04-11-2014, 04:21:32

WillSK
Quote:
Originally Posted by ShaunB-91 View Post
That won't be cheap!
But it would be awesome

I'd love to think that my next rig can be 100% SSD if the prices become reasonable enough. a 1TB HDD is about 50 quid nowadays so i'm hoping i can get a 1TB SSD for like 80 quid when it comes to it. We shall see!Quote

04-11-2014, 06:31:00

Thelosouvlakia
*^* -heavy breathing- GIBEQuote

04-11-2014, 06:36:03

Tripp
Wow would love this, although I don't think it's going to be affordable for a good few yearsQuote

04-11-2014, 07:37:09

Deceit
If it came in and around the 1k mark it would be a definite buy for me.
Its more likely to be about 3-3.5k though Quote
Reply
x

Register for the OC3D Newsletter

Subscribing to the OC3D newsletter will keep you up-to-date on the latest technology reviews, competitions and goings-on at Overclock3D. We won't share your email address with ANYONE, and we will only email you with updates on site news, reviews, and competitions and you can unsubscribe easily at any time.

Simply enter your name and email address into the box below and be sure to click on the links in the confirmation emails that will arrive in your e-mail shortly after to complete the registration.

If you run into any problems, just drop us a message on the forums.