Inwin 703 Review
Up Close: Rear and Stripped
At first view you might not think there's not a huge deal of room at the rear of the 703, however you need to remember that the case side is bulged and that more anteriorly the motherboard panel steps forward an additional 5mm. The upshot is that there's actually plenty of room back here. Add in a few well placed cable tie pints and a decent cable management job should be achievable.
The front of the case is held in place by red tabs which clip it to the chassis. It pulls away very easily with no sensation that something is about to snap. The Front I/O cables are hardwired to it though so do exercise caution and feed the wires through carefully.
With the front removed we can see that each of the fan positions benefits from a filter with both the filters and the 120mm fan being held in place by quick release clips as opposed to screws.